Set of Lister comb Pegs

You need two pins and two comb pegs for one clipper. This comprises a set.
Please note that this task needs workshop skills.
Procedure to fit is:
1. Trim off the tapered end of the plastic comb peg (2 mm)
2. Clean the socket that holds the peg to remove any oil or dirt
3. With the clipper head held firmly in a vice drive in the the comb peg with a hammer. Pegs are more likely to remain in place if held with a very small amount of super-glue (Be very careful)
4. Drive in the pin with a hammer until flush with the top of the comb peg.